Embervolt electric charcoal chimney, coals glowing and flames at the rim

Plug it in.

No fluid.
No newspaper.
No stink.

Ten minutes.
Coals ready.

Rapid electric charcoal igniter

Embervolt

The charcoal chimney with the heater built in. Plug it in, and dinner starts ten minutes sooner.

Why grillers switch

Lighter fluid stinks. Chimneys smoke out the patio. Wands burn out.

“That gasoline taste.”

Fluid soaks into the coals and into dinner. Embervolt uses heat, not chemicals. Nothing to taste.

“Newspaper, wax cubes, a lighter, and ten minutes of fanning.”

Fill it, plug it in, walk away. The chimney does the fanning.

“The wand died in a year.”

Wand starters sit in the fire. Embervolt’s heater sits under the coals in a heavy galvanized can built to take it.

How it works

Fill. Plug. Grill.

  1. Charcoal poured into the Embervolt chimney 01

    Fill

    Pour in charcoal, up to a full chimney.

  2. Embervolt plugged in with the red indicator light on 02

    Plug

    Plug it in. The light comes on. Heat starts at the base and climbs.

  3. 03

    Grill

    About ten minutes later, pour glowing coals onto the grate. Unplug and done.

Embervolt chimney, cold, showing the handle, heat shield, tripod legs and vent holes

Built for the backyard

Heavy steel. Cool handle. One light that tells you it is working.

  • Safe-Touch handle. A steel heat shield between your hand and the can.
  • Heavy-duty galvanized steel. The same gauge as a serious chimney, with a wire tripod that keeps it off the table.
  • Built-in electric element. Heat starts under the coals, so the whole load lights evenly.
  • Indicator light. Red means it is on. No guessing, no holding a button.
  • 100% chemical-free ignition. No fluid, no cubes, no smell.
  • 10-minute rapid start. From cold to glowing while you prep.
Power
110 V, standard US outlet
Cord
36 in
Chicken yakitori on a tabletop grill over glowing white binchotan charcoal

Made for white charcoal

Binchotan is hard to light. Not in here.

White charcoal is dense, clean, and burns for hours. It also laughs at matches and paper starters. Most people end up holding a torch on it.

Embervolt's heater sits right under the coals and keeps going until they catch. No torch, no gas burner, no fluid near the charcoal you paid good money for.

  • 01No torch needed. Steady heat from below does the work.
  • 02Nothing to taste. No fluid or wax, so the clean flavor binchotan is known for stays clean.
  • 03Hands free. Plug it in and walk away while it catches.

Try it

Slide to ten minutes.

Embervolt going from cold to glowing

0:00Just plugged in.

Real questions

The things people ask before they buy.

How long does it take?

About ten minutes to glowing coals with a full chimney, a little less with a half load.

Does it work with white charcoal (binchotan)?

Yes. That is one of the best reasons to own it. White charcoal is too dense for matches or paper starters, and the built-in heater keeps steady heat under it until it catches. Give it more time than regular briquettes.

How long is the cord?

36 inches, and it plugs into any standard 110-volt household outlet. If your grill sits farther from the outlet, use an outdoor-rated extension cord.

Does it stay hot after?

Yes, like any chimney. Set it on the tripod on a heat-safe surface and let it cool before storing.

Does it work in wind?

Yes. The heat comes from inside the can, so wind does not blow it out.

Do I have to hold a button?

No. Plug it in and the light tells you it is on. Unplug when the coals are ready.

Get one

Dinner starts ten minutes sooner.

$79.99

Standard outlet. Ships in the box shown.

Embervolt retail box

Selling Embervolt in your store?

Retail and wholesale orders, one email away.

Email wholesale

Hear when it ships.